Surfco Honeycomb Wax Mat

The Honey Comb Wax Mat Kit has an excellent wet grip and may be used on the decks of surfboards, skimboards, marine crafts, or any where an excellent slip resistant, non-abrasive surface is needed. They will not melt, work well in all water temperatures, and will not yellow. The tape works well with bare feet and rubber footwear. The non-abrasive grip tape will not damage clothing or wetsuits.

Wax Mat maintains its excellent grip in all temperatures and is not affected by heat or freezing conditions. The translucent white grip tape allows graphics and wood surfaces to be seen under the film. The solid color grip tapes can provide color to the deck of the board. Wax Mat will not absorb water and is easy to clean with household cleaners. A strong marine peel and stick adhesive makes the grip tape easy to apply and provides a durable bond that will not peel up.

• 12 full panels
• Excellent wet grip
• Grips like wax
• Non-abrasive to the skin
• Will not melt, no mess
• Works well in all water temperatures
• Will not yellow
• Thin see through die-cut panels
• Easy-to-apply peel and stick adhesive
• Cleans up with soap and water
• Can be used with see-through Hot Grip tail pads

Application Instructions

1. Be sure the surface is smooth, dry and clean of any dirt, wax, water, etc.  Wipe with isopropyl alcohol or xylene if necessary.
2. Select the desired location(s) and position(s) for the Wax Mat panels on the deck.
3. Surface temperature must be above 65 degrees Farhrenheit for the adhesive to bond properly to the deck.
4. Peel 3"-4" of the linter at one end of the grip tape and press onto the deck.  Then peel off the rest of the liner and press the tape onto the deck.
5. Use the end of a putty knife, J roller, or your palm and firmly press the tape onto the deck as the liner is peeled off the adhesive.  This helps prevent bubbles from forming under the tape.
6. Repeat the above process for the rest of the tape. Maximum adhesive strength is achieved in 72 hours.

Care and Maintenance

Wax Mats can be cleaned with household cleaners, dishwashing detergent or boat cleaners such as Z Cleaner.  Use a scrub brush and rinse with fresh water.  Replace worn or damaged Wax Mats.

Avoid contact with gasoline, motor oil, paint thinner, acetone, MEK, xylene, or orther petroleum products.  They may damage the grip tape. Wax Mats have an excellent wet grip and is non-abrasive to the skin. May be used on the decks of surf, skimboards, marine crafts, bathtubs and any where an excellent slip resistant, non-abrasive, see-through surface is needed.

Removal of Adhesive

1. Apply an adhesive remover such as "Goop" or "Goo Gone" and leave it on the adhesive for an hour.  This softens the adhesive.
2. Use a metal scrapper or putty knife and scrape off adhesive.
3. Wipe off any residue with a rag or paper towel.
4. Clean the surface with household cleaner or dishwashing detergent.
5. Rinse with fresh water.

Number of kits needed to cover a board:

• Shortboard: (1) kit
• Funshape: (2) kits
• Mini Tank: (3) kits
• Longboard: (4) kits for deck only or (5) kits for full deck
• SUP Nose: (1) kit
• SUP Progressive Deck: (3) kits